CreatBot D600 Pro2 HS — Technical data

The D600 Pro2 HS is the high-speed development stage of the D600 Pro range. The 600 × 600 × 600 mm build volume, chamber heated to 70 °C and filament drying remain; new are a hot end with up to 90 mm³/s flow, Klipper firmware for up to 300 mm/s and two auto-rising extruders that switch to the second nozzle when filament runs out. There is also a magnetic PEI sheet, camera, Wi-Fi and LAN and a HEPA carbon filter. A D600 Pro 2 without the HS suffix existed before; the current successor is the D600 Pro3 HS with 620 mm edge length.

When buying used, check the designation on the rating plate, as the Pro, Pro 2 and Pro2 HS look similar but differ in hot end, firmware and electronics. With 5.5 kW peak power the machine needs a suitably fused supply. The high speeds stress belts, linear guides and the hot end; ask about operating hours and maintenance status. Trigger the nozzle switch on filament run-out during the test, and have the camera and network reset. At 200 kg, a pallet truck is needed for installation.