Raise3D DF2+ — Technical data

The Raise3D DF2+ is the revised version of the DF2 DLP resin printer. Build volume (200 × 112 × 300 mm), projector resolution (2,560 × 1,440 pixels) and housing remain the same; however, Raise3D specifies a higher print speed of up to 100 mm/h, 50 to 60 mm/h in typical operation. The list of approved resins is also longer: besides Raise3D's own standard, tough, rigid, clear and ESD resins, several LOCTITE and Ultracur3D materials are available, including elastic and flame-retardant types. Control is via ideaMaker, remote management via RaiseCloud. DF Wash and DF Cure are intended for washing and post-curing.

As the DF2+ is still young, used units are rare and usually have seen little use. Nevertheless, inspect the resin tank and film, projector optics and build platform, and check warranty and purchase documents. It is important that the printer is removed from the seller's RaiseCloud account. If DF Wash and DF Cure are missing, include their purchase in the calculation.