3D Systems Figure 4 Production — Technical data

Figure 4 Production is the fully automated factory version of Figure 4 technology. A Control Cell runs cells of four print engines each, which build parts in a 124.8 × 70.2 × 346 mm volume using a DLP projector (1920 × 1080 pixels, 405 nm); washing, drying and post-curing can be integrated into the workflow. 3D Systems states up to 65 mm/h in production mode, with resin supplied from 9 kg cartridges. It is aimed at series manufacturers, for example of small parts in high volumes, who want to print around the clock with little staff.

A used Production system is a system purchase: Control Cell, print cells and post-processing should be taken over as a working set and recommissioned by the manufacturer or a service partner. Check projector hours on all print engines, tray condition, the control software and the power supply – the documented version runs on 208 V three-phase at 60 A. With more than 700 kg for the base configuration, transport also needs planning.